PVE37: Home Elevator

The PVE37 pneumatic lift requires minimal maintenance, as it lacks pulleys, greases, pistons... The PVE37 stands out for its zero impact in terms of use of polluting substances.

Being a residential lift designed for single-family homes, the PVE37 pneumatic lift has reduced energy consumption since, thanks to its vacuum technology, it harnesses the power of air to elevate two passengers inside, without consuming energy during descent.

The PVE37 pneumatic lift requires minimal maintenance, as it lacks pulleys, greases, pistons... which allows our PVE37 model to stand out as an ecological residential lift.

Additionally, as an option, it features a folding seat inside the cabin. The seat has been specially designed primarily to address physical limitations affecting passenger mobility.

External cylinder diameter: 933 mm
Maximum load: 205 kg
Capacity for two people
Speed: 15 cm/sec
No pit required.
No machine room required.
Motor power: 5kW
Power supply: 220-230V single-phase 25 A, or 380V three-phase 16 A
Electronic circuit: Command and control: 24 V.
Door passage width: 517 mm
Cabin interior diameter: Between columns: 742 mm, without columns: 821mm
Automatic LED lighting and ventilation
Telephone in cabin
Internal cabin height: 1995 mm
Door height: 1970 mm
Door height including door closer system: 2025 mm
Door/landing configuration: floors aligned at 0º. Possibility of double landings at 90º and 180º. In the 90º option, all intermediate/upper floors must be in the same position if it is 3 or 4 stops.
Door opening: Door hinge on right side – door handle on left side (from outside the lift)
A single door per floor
Optional Door hinge on left side – door handle on right side (from outside the lift)
Safety: Overload limiting valve; low cabin voltage; emergency alarm; in case of power failure, the cabin slowly descends to ground floor.
Warranty: Three years from installation.
The PVE pneumatic lift complies with the Machinery Directive 2006/42/EC
CE Marking Certification
Lift specially designed for indoor home use and installation (CANNOT BE DIRECTLY EXPOSED TO WEATHER)

The minimum height required on the upper floor is 2.70 m head format and 2.45m for split format. Check formats
The diameter of the perforation in the slab, if necessary, would be 990 mm.
The ground floor, where the cylinder rests, must be perfectly level.
In the case of installing a 3 or 5-stop lift, the circular perforations in the slabs must be perfectly aligned.
220-230V single-phase electrical power must be available through an independent line with earthing, a 25A thermomagnetic switch, and cables of corresponding section, for the exclusive use of the lift. Alternatively, 380V three-phase electrical power through an independent line with earthing, a 16A thermomagnetic switch, and cables of corresponding section, for the exclusive use of the lift.
220-230V (without exception). If the electrical installation does not guarantee a stable current, the installation of a voltage regulator or transformer is recommended. Damage caused due to voltage fluctuations is not covered by the warranty. The electrical point should be close to the vacuum motor.
Telephone connection. GSM line possibility.
For environments with reduced spaces, it is advisable to install the split format.
There must be access that allows the passage of cylinders of 990 mm in diameter and 2340 mm in length to the place planned for its installation. This access can be through doors, windows, skylights, etc.
The installation must allow for an anchor point to support minimum 800 kg in the ceiling of the place where the lift is installed to lift its cylinders. The available height on the top floor must be at least 2700 mm.
When a circular perforation in the slab is necessary for the lift installation, there must be a circular opening of at least 990mm.

PVE 37: two-person lift

Our flagship and most versatile model. Functionality, design and space in perfect harmony.